Cisco 300-206 Exam PDF Study Guide

This knowledge is valuable to attempt compulsory questions of the exam. Do not waste your time and get DumpsSchool Cisco 300-206 braindumps for stronger preparation of CCNP Security certification.

Try it Latest DumpsSchool 300-206 Exam dumps. Buy Full File here: https://www.dumpsschool.com/300-206-exam-dumps.html (430 As Dumps)

Download the DumpsSchool 300-206 braindumps from Google Drive: https://drive.google.com/file/d/1EMLvhFrYAykLS9r0FMJtmIBQ9_6i7_YC/view (FREE VERSION!!!)

Question No. 1

Due to a traffic on your network, two interface were error-disable and both interface sent SNMP traps, In which two ways can the interfaces be put back into service? (Choose two.)

Answer: A, C

Question No. 2

Which addresses are considered “ambiguous addresses” and are put on the greylist by the Cisco ASA botnet traffic filter feature?

Answer: D

Question No. 3

You are a network security engineer for the Secure-X network. You have been tasked with implementing dynamic network object NAT with PAT on a Cisco ASA. You must configure the Cisco ASA such that the source IP addresses of all internal hosts are translated to a single IP address (using different ports) when the internal hosts access the Internet.

To successfully complete this activity, you must perform the following tasks:

* Use the Cisco ASDM GUI on the Admin PC to configure dynamic network object NAT with PAT using the following parameters:

* Network object name: Internal-Networks

* IP subnet: 10.10.0.0/16

* Translated IP address: 192.0.2.100

* Source interface: inside

* Destination interface: outside

NOTE: The object (TRANSLATED-INSIDE-HOSTS) for this translated IP address has already been created for your use in this activity.

NOTE: Not all ASDM screens are active for this exercise.

NOTE: Login credentials are not needed for this simulation.

* In the Cisco ASDM, display and view the auto-generated NAT rule.

* At the CLI of the Cisco ASA, display your NAT configuration. You should see the configured policy and statistics for translated packets.

* At the CLI of the Cisco ASA, display the translation table. You should see dynamic translations for the Employee PC and the Guest PC. Both inside IP addresses translate to the same IP address, but using different ports.

You have completed this exercise when you have configured and successfully tested dynamic network object NAT with PAT.

Answer: B

Question No. 4

When a Cisco ASA is configured in transparent mode, how can ARP traffic be controlled?

Answer: A

Question No. 5

Refer to the exhibit.

Which option describes the role of the filter rule on this cisco ASA firewall?

Answer: D

Question No. 6

A network engineer is troubleshooting and configures the ASA logging level to debugging. The logging-buffer is dominated by %ASA-6-305009 log messages. Which command suppresses those syslog messages while maintaining ability to troubleshoot?

Answer: D

Question No. 7

Which statement about Cisco ASA multicast routing support is true?

Answer: D

Question No. 8

What are two reasons for implementing NIPS at enterprise Internet edges? (Choose two.)

Answer: C, D

Question No. 9

What are the three types of private VLAN ports? (Choose three.)

Answer: A, B, C

Question No. 10

You fail to communicate with a target device by using the Cisco Security Manager console. Which two tasks do you perform to allow communication? (Choose two)

Answer: C, D

300-206 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1EMLvhFrYAykLS9r0FMJtmIBQ9_6i7_YC/view

Exam Vendor: Cisco dumps